Description
Diff Breather Kit 6 point.(Front and Rear Diff, Transfer case, Gearbox and 2 Auxiliaries )
Australian Stock and in stock ready to ship.
Kit Includes:
4 x Pneumatic Push In Air Fittings – Male Connector 6mm hose – 1/8 thread
2 x Pneumatic Push In Air Fittings – Male Elbow 6mm hose – 1/8 thread
2 x Brass Barb Fittings for easy connection to existing breather pipes if necessary 6mm
2 x Brass Barb Fittings for easy connection to existing breather pipes if necessary 8mm
1 x Stainless Steel Brackets
15 x meters of 6mm PU hose
6 x Pneumatic Push In Air Fittings – Female Bulkhead Connector 6mm hose – 1/8 thread
6 x 1/8 Filter
Fits most 4×4 except Ford Courier/Everest/Ranger PX/2/3/Mazda BT-50 DB1002 /Iveco Daily as they use an M8 thread on the breathers see our other kits.
the Purpose of a Diff breather kit is to allow for the equalisation of pressure when a hot Diff, Transfer Case, Gearbox or other item fitted with a breather comes in contact with cold water and cools down this creates a pressure drop and can suck water in through the original breather or warn bearing seals. Introducing water contaminating the oil and reducing or catastrophically damaging your Diffs, Gearbox or transfer case and other equipment.
.
- INSTALLATION TIPS–Due to the different locations of Gearbox & Transfer case Breather positions this kit should be installed by a qualified mechanic or knowledgeable person a hoist is an advantage.
- Some Transfer Cases, Gearboxes & Diff will not have a Threaded fitting they may have a top hat or hose in these cases they will need to modify to take a rubber hose to be connected and then allow connection to your diff breather kits with a Hose Barbs fitting.
- PLEASE NOTE ADDITIONAL COMPONENTS MAY BE REQUIRED TO INSTALL THIS KIT DEPENDING UPON YOUR VEHICLE APPLICATION.
- PLEASE NOTE Airparts takes no responsibility for the installation or responsibility of the person instaling the kit it is supplied as a component only kit
- IMPORTANT NOTE: IT IS THE VEHICLE OWNERS’ RESPONSIBILITY TO CHECK & MAINTAIN THE KIT AFTER INSTALLATION,
Check all hoses are always securely installed within the fittings in Diffs, Transfer Case, Gear Box or Transmission and other points have not been DAMAGED buy driving or off-roading that would allow Dust, Water & other unwanted contaminants to enter. - AirParts takes no responsibility for the use of this kist or damage that may be caused by this kit it is designed to be a component only kit for the 4 x 4 enthusiast and used at your own risk.
Installation
- Locate all Breathers and install appropriate Fitting.
- Install 6mm hose into fittings and use cable ties to arrange the hose away for heat sources and mechanical pinch points and route to the engine bay.
- Install the 6mm hoses into the female bulkheads mounted in the bracket .
- Make sure all components are secure and away from direct heat sources and mechanical pinch points.
- Inspect on a regular interval to make sure no Branches or other obstacles that have been negotiated when off-roading have damaged to detached the breathers or contaminates may enter the system.
- It is your own responsibility to work safely on your vehicle or engage a licenced mechanic.
- Always use UV stabilised cable ties.
- Use split loom where needed to protect the PU tube from damage or rubbing.
